| PCI Express Slot/Extender/Riser card | PCI Slot/Extender/Riser card |
| PCI card plugged into connector figure |
PCI-ISA Gold Fingers Protector/Slot/Riser card/Test socket 120p +98p
Open-Short test card
Attention:
1. Whole signals bus Test Socket/Converter/Extender maybe not 100% one to one(1:1)
convert, please check specification.
2. No matter how many Slot/Socket, PCI series only can use one Slot/Socket at a time.
3. All Converters/Test Socket/Riser card/Extender have Timing, Delay, Impedance,
Resistance Contact problem, so we can't guarantee can work100%.
4. External converter card, if occur unstable, try to shorten the cable to better this status.
|
|
|
|
 |
 |
|
|
 |
 |
 |
 |
| CV08PI-S Gold Fingers
Protector * To extent the gold fingers/slot life. |
inquiry |
| Slot/Extender/Riser card/Test socket | |
| * Change or extend the Add-in card insert position (Right-insert) Right-angle/side slot x2, for Add-in card insert to Right slot(Solder side up), Form Factor: 2U (Left-insert) Left-angle/side slot x1, for Add-in card insert to Left slot(Component side up), Form Factor: 2U (Stand-insert) Stand type slot x1, for Add-in card insert to top slot(No change position). * Easy for Logic Analyzer and Oscilloscope to measure PCI-ISA bus every pin signal. * The Gold fingers pin to pin(1 to 1) connect to slot, VDD-Power/VSS-Ground the common pin didn't connect with together. |
|
| 1. CV08PI-Rx2(Right insert slot x2) Form Factor: 2U | inquiry |
| 2. CV08PI-L(Left insert slot x1) Form Factor: 2U | inquiry |
| 3. CV08PI-RL-PCB | inquiry |
| Option +L: Add Left-angle/insert slot x1 | |
| Option +S: Add Stand/Top-insert slot x1 | |
| Option +PH: Add PH=68p x4 Pin Head | |
| Option: Add Half pitch ATA-100 flat cable x30cm | inquiry |
| Option Half pitch twisted flat cable | inquiry |
| Option Teflon flat cable | inquiry |
| CV09PI test socket
* Easy for Logic Analyzer and Oscilloscope to measure
PCI-ISA bus every pin signal. |
inquiry |
| PCI-ISA to PCI-ISA external
card
* with ATA-100 cable length= 45cm, Form Factor: 2U |
|
| 1. CV09PI-eRx2(Right insert slot x2) | inquiry |
| 2. CV09PI-eL(Left insert slot x1) | inquiry |
| Option +L: Add Left-angle/insert slot x1 | |
| Option +S: Add Stand/Top-insert slot x1 | |
| Option: Add Half pitch ATA-100 flat cable x30cm | inquiry |
| Option: Half pitch twisted flat cable | inquiry |
| Option: Teflon flat cable | inquiry |
|
 |
CV-11PI PCI-ISA Open-Short test card
Function:
Did you ever burn your mother board, Add-On card, or other peripheral?
Too many circuits between mother board and Bus-Slot, so if mother board dead, shall
test circuits open/short at first, it's helpful for repair.
Open-Short Test Card Merits:
1. Save money: Avoid mother board, Add-on card, or other peripheral burned for shortage circuit.
2. Save time: Open-Short test complete only take few minutes for bus pin to pin;
or circuits between mother board and Bus-Slot.
3. Convenient: Easy use and carry.
4. Powerful:
a. Just test one-pin, can find out multi-pin shortage, it's helpfulness than Scope and Meter.
b. Test Open-Short no need Oscilloscope and Meter, because Scope very
difficult to distinguish HI-level and VCC, LOW-level and GND signal.
| Home | Index |   |
Start: 24/10/2005 Update: 10.04.2009
