RTP-03D PCI Dual Rs485/ Printer Card

Feature:

Serial ports:

* The external i/o are done through two 9-pin male connectors.

* 16 byte transmit-receive FIFO (UART).

* Programmable baud rate by software.

* Serial's operating clock select by hardware. (operate speed max. up to 1384kb/s)

* Address mode: plug & play or re-map to isa address 3f8H, 2f8H, 3e8H, 2e8H.

* Two independent RS-422/485 interface.

* Uart (16C450, 16c550, 16C650, 16C750, 16C850) hardware compatiblity.

* Asyncronous communication protocol.

* Supports Tx, Rx, RTS and CTS signal.

* Two or four wire operation : 422 / 485 select by jumper.

* RS485 Rreceiver jumper setting : always on, RTS or Control-bit-enable.

* On board termination resisters.

* Distance up to 3000 ft.

* Baud rtae up to 56K bauds (16C450)

* Baud rate up to 115.2K bauds (16C550, 16C650, 16C750, 16C850)

* RS-422 feature : connection number -- 1 Driver, 10 Receivers.

Transmission distance / speed : 

12 M / 10 M (bit/sec), 120 M / 1 M (bit/sec), 1200 M /100 K (bit/sec)

* RS-485 feature : connection number -- 32 Driver, 32 Receivers.

Transmission distance / speed : 

12 M / 10 M (bit/sec), 120 M / 1 M (bit/sec), 1200 M /100 K (bit/sec)

Parallel port:

* Multi-mode compatible (SPP, BPP, EPP, ECP).

* First data rates up to 1.5 Mbytes/s.

* Can support 16 byte FIFO.

* Address mode: plug & play or re-map to isa address 378H, 278H.

* Board's interrupt select by hardware.

* Driver support: Win95b, 98, Me, Xp, Win2000, Win Nt, Dos and Linux system.

Start: 3/7/2003 Update: 02.15.2011